PRJ - Analog Read Serial#
From: Analog Read Serial —— Arduino Documentation | built-in examples
电路连接#
Code List#
/*
AnalogReadSerial
Reads an analog input on pin 0, prints the result to the Serial Monitor.
Graphical representation is available using Serial Plotter (Tools > Serial Plotter menu).
Attach the center pin of a potentiometer to pin A0, and the outside pins to +5V and ground.
This example code is in the public domain.
https://www.arduino.cc/en/Tutorial/BuiltInExamples/AnalogReadSerial
*/
// the setup routine runs once when you press reset:
void setup() {
// initialize serial communication at 9600 bits per second:
Serial.begin(9600);
}
// the loop routine runs over and over again forever:
void loop() {
// read the input on analog pin 0:
int sensorValue = analogRead(A0);
// print out the value you read:
Serial.println(sensorValue);
sensorValue = analogRead(A1);
Serial.println(sensorValue);
delay(1000); // delay in between reads for stability
}
模拟引脚命名以 A
开头
模拟读的结果不一定得是小数,也可以是放大后的整数,这是更常用的做法
A0 读数的范围是多少呢?
转换成电压#
前面的读数为整数,可进一步转换成电压:
void loop() {
// read the input on analog pin 0:
int sensorValue = analogRead(A0);
// Convert the analog reading (which goes from 0 - 1023) to a voltage (0 - 5V):
+ float voltage = sensorValue * (5.0 / 1023.0);
// print out the value you read:
Serial.println(voltage);
}